Applications ?PC Motherboards ?Graphics Boards ?
Notebook PCs
Si I 1162PanelLink Transmitter
SiI 1162 DVI-compliant “eye”diagram measured at 200 MHz.
The SiI 1162 is a DVI-compliant transmitter incorporating next- generation PanelLink ?technology to support the full DVI bandwidth of 25 to 165 MHz.As a result,the SiI 1162 supports LCD monitors and projectors with resolutions that range from VGA to UXGA (1600 x 1200).Three TMDS TM data channels for RGB send data at up to 1.65 Gbps per channel.The SiI 1162 incorporates an industry-standard 12-bit (1/2 pixel per clock edge) interface for true color (16.7 million) support.Built-in flexibility enables customers to use pins to configure settings or the I 2C interface to program registers.The SiI 1162 is available in a low-cost,easier-to-use,48-pin TSSOP package with a 40% smaller footprint compared to other discrete DVI transmitters.By incorporating the most advanced PanelLink DVI technology available today,the SiI 1162 transmitter brings higher performance and guaranteed compatibility to your DVI applications while enabling faster time to market,smaller form factor designs and lower system costs.
DVI-compliant Quality
The DVI 1.0 specification defines the precise system-level signaling at the output of a DVI transmitter system and at the input of a DVI receiver system.As a result,any DVI-compliant host will always interoperate with any DVI-compliant display.The most comprehensive
method to determine the quality and compliance of a DVI transmitter is to measure the TMDS “eye” diagram as defined by the DVI 1.0 specification and the DVI T est & Measurement Guide.Only high-performance PanelLink DVI transmitters,such as the SiI 1162,yield consistently
robust differential signal “eyes” that exceed the minimum “eye” width & height requirements of the DVI specification at the full DVI bandwidth of 25-165 MHz.
?2002 Silicon Image,Inc.All rights reserved.Silicon Image,the Silicon Image logo,SiI,SiI 1162,PanelLink,the PanelLink logo and TMDS are trademarks or registered trademarks of Silicon Image,Inc.in the United States and other countries.Other trademarks are the property of their respective holders.Product specifications are subject to change without notice.Printed in the U.S.A.9/02 SiI PB-0032Silicon Image,Inc.
1060 E.Arques,Sunnyvale,CA 94085 T 408.616.4000 F 408.830.9530 https://www.docsj.com/doc/0d6865234.html,
SiI1162 Features PanelLink? T ransmitter ?Scalable bandwidth from 25 to 165 MHz (VGA to UXGA)?Three TMDS TM data channels capable of transferring up to
1.65 Gbps per channel
?Inter-pair skew tolerance up
to 1 input clock cycle (6 ns at 165 MHz)
?Adjustable TMDS low-voltage swing amplitude for long cable support
?DC-balanced signals for direct coupling to fiber-optic ready modules
?Operates with all DVI 1.0-compliant receivers
?Supports Hot Plug Detect and Receiver Sensing
Input
?Flexible graphics controller interface: 1.0V - 1.9V (DVO) or 3.3V (CMOS) interface voltages
?12-bit input for true color (16.7 million) support
? De-skewing option to vary clock to data timing
?Supports dual-edge single clock or dual-edge differential clock ?Selectable primary edge of parallel data
?Programmable through I2C interface or configurable by pin settings Power Management
? 3.3V core provides low-power
operation
? Low-power standby mode
Data Capture
Block
PanelLink
Transmitter
Registers
and
Configuration
Logic
I2C
Slave
Voltage Voltage Swing
Si1162
I
Part Number - SiI1162CS48
Silicon Image’s
SiI1162 Starter Kits
SiI1162 starter kits are available for
various motherboard and graphics
chipset platforms.For details,please
see Starter Kits/Reference Designs on
the Silicon Image website at
https://www.docsj.com/doc/0d6865234.html,
Si I1162PanelLink Transmitter